Frame rake
#1
Frame rake
Got a few questions. I have a 2005 1200C. I would like the front raked out to about 40 degrees. How is this done with my frame. I dont see how the angle of the goose neck can be changed the way it's all welded together. How can the down tubes be lengthened the way the front cylinder mounts to the frame with that swing arm? I have looked around, and cant find a raked frame for 04 and later sportsters.
#3
Got a few questions. I have a 2005 1200C. I would like the front raked out to about 40 degrees. How is this done with my frame. I dont see how the angle of the goose neck can be changed the way it's all welded together. How can the down tubes be lengthened the way the front cylinder mounts to the frame with that swing arm? I have looked around, and cant find a raked frame for 04 and later sportsters.
As for the engine mounts, as stated in the other thread, you just need to have the welder modify them, or relocate them on the downtubes. If whoever is planning on doing the fabrication work can't figure that out....I'd find a different fab guy.
Thread
Thread Starter
Forum
Replies
Last Post
tattooedskin
Want To Buy Motorcycles/Parts/Accessories
0
06-29-2006 04:35 PM