Stock seat
#1
Stock seat
So I feel very dumb in asking this but I searched all over and unless I was using poor searching parameters I couldn't find the answer. I took off my 2-up seat to put the stock solo seat back and to my surprise instead of a threaded hole on the fender it's a keyed slot. How do I connect the solo seat? Thank you
#2
#5
#6
I would prefer to buy a second one so I don't have to keep swapping back and forth. What are they called because I've done a couple google searches and can't seem to find the component. Much appreciated
You can swap the fastener from the back slot to the front. Your dealer will have the fastener or you can order one online. They're cheap.
Use a bit of wire to get the fastener through the fender and hold it there while you slip the tab on. Easiest way to do it that I've found.
Use a bit of wire to get the fastener through the fender and hold it there while you slip the tab on. Easiest way to do it that I've found.
#7
Trending Topics
#8
#9
#10
Ok here ya go. I have spares so went and looked.
HD part # 59768-97 fender/seat nut kit
This is the piece that goes through the fender
HD part # 2952A screw, sems truss head
This is just the screw to hold the seat on. I have one in my parts box but you can get something at the hardware store a LOT cheaper.
JP Cycles item # 8200095 seat mount nut $4.00
HD part # 59768-97 fender/seat nut kit
This is the piece that goes through the fender
HD part # 2952A screw, sems truss head
This is just the screw to hold the seat on. I have one in my parts box but you can get something at the hardware store a LOT cheaper.
JP Cycles item # 8200095 seat mount nut $4.00
Last edited by whiskey girl; 07-15-2012 at 11:17 AM.