HARLEY: Map for TC96" with stage 1 and 255 cams
#1
Map for TC96" with stage 1 and 255 cams
Hi for everyone,
I have a plan to change cams in my FXDC 2008 96" from OEM to 255. I know that maybe there are better cams, but I will have these. I rode on similar Dyna but 103" with 255 and that's what I would like to have. Mechanical part of this job isn't a problem for me. I have enough experience.
But main problem I have with maps. I have SERT, I used it many times, not only on my bike. But officially there is only map for 103" stage 2 with 255 cams. My question is what else should I change to have correct one map. I know that in "tunning setup" I can change engine displacement from 103" to 96", but I'm not sure what else should I change.. Any ideas ?
Regards,
Pawel
I have a plan to change cams in my FXDC 2008 96" from OEM to 255. I know that maybe there are better cams, but I will have these. I rode on similar Dyna but 103" with 255 and that's what I would like to have. Mechanical part of this job isn't a problem for me. I have enough experience.
But main problem I have with maps. I have SERT, I used it many times, not only on my bike. But officially there is only map for 103" stage 2 with 255 cams. My question is what else should I change to have correct one map. I know that in "tunning setup" I can change engine displacement from 103" to 96", but I'm not sure what else should I change.. Any ideas ?
Regards,
Pawel
Thread
Thread Starter
Forum
Replies
Last Post