Repair Shop in Palm Beach or Broward County
#12
#14
http://www.lugnutcustoms.com/ in Rivera Beach, they are also Harley authorized.
For a class check out South Tech in Boynton, it's a Monday eve class 8 weeks, about $140, I took it a few times, well worth it. They have one coming up soon.
For a class check out South Tech in Boynton, it's a Monday eve class 8 weeks, about $140, I took it a few times, well worth it. They have one coming up soon.
#16
For a class check out South Tech in Boynton, it's a Monday eve class 8 weeks, about $140, I took it a few times, well worth it. They have one coming up soon.[/QUOTE]
Jerry, do you know how often this is offered? On line it still shows the spring schedule (last May 2015). Might it be offered this coming Fall, as well?
Jerry, do you know how often this is offered? On line it still shows the spring schedule (last May 2015). Might it be offered this coming Fall, as well?
#17
Join Date: May 2012
Location: Port St Lucie Florida
Posts: 11,396
Received 3,389 Likes
on
1,560 Posts
#18
For a class check out South Tech in Boynton, it's a Monday eve class 8 weeks, about $140, I took it a few times, well worth it. They have one coming up soon.
Jerry, do you know how often this is offered? On line it still shows the spring schedule (last May 2015). Might it be offered this coming Fall, as well?
Jerry, do you know how often this is offered? On line it still shows the spring schedule (last May 2015). Might it be offered this coming Fall, as well?
http://www.pbeducator.org/pbeducator...ts_per_page=10
#19
I had my rear wheel off today to replace a warped brake rotor. Unfortunately, my compressor wasn't up to the job of driving the impact gun hard enough to break the 5 rotor bolts loose. So, I hauled the wheel and new rotor over to Steel Knuckle to let them do the 5 minute job (5 bolts - out & in). Ouch.........
#20
Join Date: May 2012
Location: Port St Lucie Florida
Posts: 11,396
Received 3,389 Likes
on
1,560 Posts
FYI - Steel Knuckle has a minimum shop charge of $50.00.
I had my rear wheel off today to replace a warped brake rotor. Unfortunately, my compressor wasn't up to the job of driving the impact gun hard enough to break the 5 rotor bolts loose. So, I hauled the wheel and new rotor over to Steel Knuckle to let them do the 5 minute job (5 bolts - out & in). Ouch.........
I had my rear wheel off today to replace a warped brake rotor. Unfortunately, my compressor wasn't up to the job of driving the impact gun hard enough to break the 5 rotor bolts loose. So, I hauled the wheel and new rotor over to Steel Knuckle to let them do the 5 minute job (5 bolts - out & in). Ouch.........
ouch, didn't know that. I use them for service on my Springer