THIS GUY APPROVES

 

What do you use to stick these lights to your bike?

 

The lights that I use come from AutoZone and they have double sided 3m tape on the back.

2010 Limited with some stuff!!

 

The LED strips have 3M double stick tape on them, same stuff you would use for trim pieces on a car. It was a very simple install. I got the adaptor www.pmlightglide.com makes for the harness under your seat. I just flip the acc switch and I'm good.

 

[/QUOTE] Extreme visibility at night, I don't ride in the dark without them on[/QUOTE]

Everyone should check their state law before they invest in them. It is illegal to run with them in Virginia. Some people have them anyway. But if a cop wants to stop and ticket you he can.

 

The only problem with using the accessory switch is it doesn't allow you to leave the lights on once you've turned the bike off.

2010 Limited with some stuff!!

 

Hmm, I guess Calif is the only state that would not allow colored lights like that. Last time I checked it was amber only no more than 6" from the front most point, and red only no more than 6" from the rear most point. Dont mean to crap on ya'alls BD cake but theres enough other reasons to get pulled over.IMO

 

Come to the Republic of Texas...you arent even required to have lighted turn signals on a bike.

 

Ended up buying a kit from the Vegas bike fest in October from Pyrotexxx.com. They were there doing installs, lights are very nice. Paid $275 for a full kit that includes 2 remotes, lights are blue and have 3 mode settings.

This will be my winter install project. Just noticed that they raised their prices by $100 bucks now. I like em on the bikes, more visibility at night!

 

Where's the LIKE button?