I can't remember who but I know at least one member has one. Just curious as to what all is involved in installation. Any hole drilling? Or just adhesive?

Thanks in advance,

Primo

 

Bueller? ....Bueller? (cricket....cricket....cricket...

 

Please don't install this on that beautiful bike.

 

I have an 06 ULTRA & do not care much for the looks of the dash pad cover. I been thinking about the multi pocket windshield pouch. Any comments on the pouch? mounting etc.

 

Didnt think i would like the dash cover but I saw one on a SG at bike week and it actually looked really nice. However it didnt really stand out like I have to run and buy one but like I said,not bad!!

 

The best multi-pocket windshield pouch that they had (in my opinion) was the one that they discontinued. It had "through the cover" turning clasps to keep it shut- much more reliable than velcro.

 

Yes you have to drill holes in the fairing (looked at the installation page, did not buy)

 

Well that leaves that one off the list. Thanks milwaukee and everyone else.

primo

 

I installed a dash pad on my '03 ultra. Drilled two holes using the H-D templets. Piece of cake, but I must admit, I was a bit cautious after seeing that 1/2" holes needed to be drilled through my freshly painted inner fairing. I trimed off the two outer bags from the fairing three bag pouch.
I like it! I don't think I would have trimed off the outer pouches if I had left the 12" windshield but with the dark wind deflecter shield all is good.



chappy