Tap into 12v wiring up front
#1
Tap into 12v wiring up front
Hi,
I am getting set to wire up my new Zumo 550 and was looking for some suggestions as to what wires I could tap into for 12 volt power inside the nacelle.
I have all the connectors that I need (I think), I just need to know which is the best + and - wires without digging through the manual.
 \\;
This is an edit:
I thought I should go back to the original post and mention that this is a 2000 Road King. It seems it has a different wiring harness than the one that responders have been referencing.
Thanks,
Murph
I am getting set to wire up my new Zumo 550 and was looking for some suggestions as to what wires I could tap into for 12 volt power inside the nacelle.
I have all the connectors that I need (I think), I just need to know which is the best + and - wires without digging through the manual.
 \\;
This is an edit:
I thought I should go back to the original post and mention that this is a 2000 Road King. It seems it has a different wiring harness than the one that responders have been referencing.
Thanks,
Murph
#2
RE: Tap into 12v wiring up front
I should have taken pictures, but it is quite easy. I bought two small blade connectors to put on the Zumo leads and they plugged right into the open spare connectors behind the headlight. I just pulled off the windshield and the fairing, plugged it in and it was done. Be careful with the the lower left screw that attaches the fairing. I lost the sucker and I was lucky to get the last one at the dealer.
#3
#4
#6
#7