Electronic throttle problems on 09 Road King
#1
Electronic throttle problems on 09 Road King
Just rode an 09 Road King, had the fly-by-wire throttle act up during the ride and remained in idle with no throttle response, despite restarting. Had to let it sit for an hour or so, before it could start up normally with a throttle response.
Another hour into the ride, the problem came back.
Anyone else had better luck with the 09 electronic throttle?
Another hour into the ride, the problem came back.
Anyone else had better luck with the 09 electronic throttle?
#4
#7
Trending Topics
#9
Next is your connectors are just not male into female or the wire on one of the connectors is pushed out and just touching are some wire shorts/no signal type sensor defaults as in the sensor is good is it the wire (harness) or connector in between the ECM and the sensor itself, meaning the grip.
#10
Sounds classic. Sensor not dialed-in to the 0 to 5V signal is move the sensor to center (sorta find the middle between WOT (wide open throttle) and idle, (or closed throttle say).
Next is your connectors are just not male into female or the wire on one of the connectors is pushed out and just touching are some wire shorts/no signal type sensor defaults as in the sensor is good is it the wire (harness) or connector in between the ECM and the sensor itself, meaning the grip.
Next is your connectors are just not male into female or the wire on one of the connectors is pushed out and just touching are some wire shorts/no signal type sensor defaults as in the sensor is good is it the wire (harness) or connector in between the ECM and the sensor itself, meaning the grip.