WardsPartWerks FCS cooling fan install with Howards Hog Horns
#1
WardsPartWerks FCS cooling fan install with Howards Hog Horns
This weekend I installed a Wards Parts Werks FCS cooling fans on the ol RK. It is combined mounting with a Howards hog horn so I took a few pictures for anyone considering the same install. Quality of the fans is excellent BTW.
pic 1 Howards hog horn (before)
pic 2 remove compressor
pic 3 modify horn mounting bracket by extending notch 1/2 inch deeper
pic 4 remount bracket in new notch
pic 5 mount fan assembly and level
pic 1 Howards hog horn (before)
pic 2 remove compressor
pic 3 modify horn mounting bracket by extending notch 1/2 inch deeper
pic 4 remount bracket in new notch
pic 5 mount fan assembly and level
Last edited by Peekayphx; 03-13-2013 at 09:05 AM. Reason: added pictures incorrectly
#2
pic 6 tighten it down https://www.hdforums.com/forum/attac...1&d=1363142661
pic 7 switch for fans https://www.hdforums.com/forum/attac...1&d=1363142661
pic 8 clean up wiring https://www.hdforums.com/forum/attac...1&d=1363142661
pic 9 install complete https://www.hdforums.com/forum/attac...1&d=1363142661
pic 7 switch for fans https://www.hdforums.com/forum/attac...1&d=1363142661
pic 8 clean up wiring https://www.hdforums.com/forum/attac...1&d=1363142661
pic 9 install complete https://www.hdforums.com/forum/attac...1&d=1363142661
#4
#6
#7
Trending Topics
#8
Just installed mine a couple of days ago. Went on a 755 mile ride through SE Ohio. Rode the OH-555 (Triple Nickel) and my oil temps never exceeded 235*. Works fantastic and great workmanship. My concern here is is there too much weight hanging from the one vibration isolator mount bolt and did you maintain a minimum 1/4" clearance from the cylinders as specified in the installation instructions?
#9
Thread
Thread Starter
Forum
Replies
Last Post