Been contemplating this for some time and have just about convinced myself to pull the trigger. I have a few concerns that haven't been answered by Camtech themselves so figured I'd ask here.

• Bike gets ridden 15k+/year and never sees a trailer. It's not custom by any means, just perfecting it for me.

• anyone use this product? pros and cons would be appreciated.

• fitment issues? does this thing seal up properly to a batwing outer shell? Last thing I want is going this route and spending all the $ required to do this only to have water run down inside of it because it doesn't fit/seal properly ruining everything.

• any other issues?

• any pics by chance?

Thanks,
UN

 

If it is like the other camtech products i have used, they are some quality stuff.

 

what other products have you used if you don't mind me asking?

 

I have their rear fender (+6) and bags (+4). Good quality stuff.

 

I have not used any of their products but had alot of work done by them on my SG when Robbie was there and they were first class.

 

UN I know you are over on one of the "other" forums, hit up Ken/Outlaw Custom Baggers and see if has worked one of their fairings.

 

Much appreciated sir! I'm really just trying to figure out what I'm getting myself into by doing this. :-)

 

humor me for being uninformed, but what is a Camtech Custom Beaten Inner Fairing Batwing ?

 

http://www.camtechcustom.com/bagger_..._fairing1.html

 

That is nice. $900 is a bit steep though.