Ported and polished heads
07-23-2016, 07:29 AM
Join Date: Jul 2016
Location: New Hampshire
Posts: 19
Received 0 Likes
on
0 Posts
Were these cnc or hand ported were they milled to change the chamber size? why did you remove? front motor mount bolt hold?
07-23-2016, 08:52 AM
Join Date: Sep 2015
Location: Kansas
Posts: 281
CNC valve job and hand ported I'm not sure the chamber size I would have to check but I am selling bc I never had them on I went a different route
07-23-2016, 01:42 PM
Join Date: Jul 2016
Location: New Hampshire
Posts: 19
Received 0 Likes
on
0 Posts
would luv to see some more pics, chambers intake exhaust and do they have front motor mount?
07-25-2016, 06:24 AM
Join Date: Sep 2015
Location: Kansas
Posts: 281
pm me your phone number and i can take some pics for you after work
07-27-2016, 04:17 AM
Join Date: Jul 2016
Location: New Hampshire
Posts: 19
Received 0 Likes
on
0 Posts
phone screwed up more pics here?
07-27-2016, 07:58 PM
Join Date: Aug 2012
Location: Ft. Myers,FL.
Posts: 270
Likes: 0
Any flow numbers from when done?? If so and they're good I'll take them for $300 shipped
07-28-2016, 06:10 AM
Join Date: Sep 2015
Location: Kansas
Posts: 281
i got no flow numbers on these but i would imagine they are in the 150 cfm range
07-28-2016, 06:15 AM
Join Date: Aug 2012
Location: Ft. Myers,FL.
Posts: 270
Likes: 0
08-11-2016, 08:01 AM
Join Date: Sep 2015
Location: Kansas
Posts: 281
08-11-2016, 12:07 PM
Join Date: Jul 2007
Location: Ocean View, DE
Posts: 179
Likes: 0
bedelman,
I have watched this thread for some time and am interested. However, no one is going to buy something that won't fit. This is a section for Touring Parts. If you cannot verify whether the heads are machined for late model Touring mount on the front head, I doubt you will get anyone to pull the trigger.