Well....putting on my new avon grips and now when I turn the ****, hit the ignition switch and won't start. It makes the power up noise when you turn the know but nothing comes on the screen...
Not sure if it's something on the throttle side or clutch side that is messed up.

 

I would start with checking the fuses and looking for pinched wires.

 

Checked all fuses and they are fine and all the wires look fine

 

Could be on the clutch side. Have you tried staring in gear with the clutch pulled in and your foot on the brake?

 

Well after cutting an inch off the heal shrink wrap looking for a crimped wire I then went to the clutch side loosened it all up and it started.
Tightened it all back up and continues to start.
of course now have to get more heat shrink to cover the part I cut.....

thanks all....

 

To good to be true... now engine light on

 

Could be a historical code sent when you had the error. Check the code first and then clear it.

 

These are the codes I had:
ECM
U0001
U0140
U0141
U0142
U0156

BCM
62208
U0001

Went thru and cleared them and the engine light went off and those codes did not come back EXCEPT BCM 62208 that one even when I hit "clear" will not go away.

 

The apt on my phone for DTC codes keeps coming up with battery voltage low??

 

Check out this thread. Talks about a short. https://www.hdforums.com/forum/new-r...ode-p1356.html