Someone asked me to post these pics. Please excuse the dirty bike
[8D]
Parts were less than 10 bucks,2 30" 3/8s chrome over copperlav supply lines from Lowes, 6"
of 3/8 gas line some 3/8s clamps and some black drawtites... I took the line that reversed back into
the K&N off andjust added the 3/8s lav line to it there. I cut it after bending where it I wanted it
at the 90 angle back down to the brake line.Run another one from the rear and bend it till you like the fit and use the drawtites to connect the line to the frame ( make sure to dump the oil where it dont get on your tire). I laced mine under the brake line to keep it from moving or rattling.Trim the excess off the drawtights and no more oil in your filter...
I do think I am going to cut the rear line off flush where the muffler mount ends , but I am installing a hooker header next week and figure I may have to reroute some stuff then so I am waiting till then.
[IMG]local://upfiles/30673/8A42494E3B7D45279C13A7F7BF54B5A2.jpg[/IMG]
[IMG]local://upfiles/30673/A01D491EDA43429B93FA62F33A1BF9C6.jpg[/IMG]
[IMG]local://upfiles/30673/398B4D2E7E194059862E21FDD6D113FF.jpg[/IMG]
oil diverter mod pics
