Alarm light stays on....
Thread Starter
|
Road Master
Joined: Jan 2008
Posts: 771
Likes: 1
From: Connecticut
Alarm light stays on....
I have a 2007 Ultra and installed the Kuryakyn Panacea taillight and rear turn signals.
I now installed the LED front turn signals and they work fine for 4/5 blinks and then the alarm light goes on, then they blink fast.
They work but just very fast.
I've tried 1 load resistor, 2 load resistors, no differnece.
Disconnected the battery to reset the master control, no help.
Any ideas?
TIA,
Charlie
I now installed the LED front turn signals and they work fine for 4/5 blinks and then the alarm light goes on, then they blink fast.
They work but just very fast.
I've tried 1 load resistor, 2 load resistors, no differnece.
Disconnected the battery to reset the master control, no help.
Any ideas?
TIA,
Charlie
Tourer
Joined: Oct 2007
Posts: 331
Likes: 1
From:
RE: Alarm light stays on....
You need a load equilizer. You're bike thinks you have blown a bulb because of the decreased resistance in the circuit with the LED's.
You're best bet is a biketronics smart equilizer. The resistors that you put in line generate heat as they simulate load. Who needs that?
RJ
You're best bet is a biketronics smart equilizer. The resistors that you put in line generate heat as they simulate load. Who needs that?
RJ
Thread
Thread Starter
Forum
Replies
Last Post
rangerider547
Electrical/Lighting/Alarm
1
May 17, 2016 03:41 PM
SOCALLOWBOY
Ignition/Tuner/ECM/Fuel Injection
2
Jul 27, 2012 11:29 AM
