Alarm light stays on....

Harley Davidson Forum

Sponsors

Harley Davidson History

Alarm light stays on....

Printable Version

Harley Davidson >> General Harley Davidson Tech Forums >> Electrical/Ignition/Tuner/ECM/Fuel Injection >> Alarm light stays on....

Page: [1]

Message

<< Older Topic Newer Topic >>

Alarm light stays on.... - 5/10/2008 6:02:50 AM

cfmii11

Posts: 166
Joined: 1/24/2008
Status: offline

I have a 2007 Ultra and installed the Kuryakyn Panacea taillight and rear turn signals.
I now installed the LED front turn signals and they work fine for 4/5 blinks and then the alarm light goes on, then they blink fast.
They work but just very fast.
I've tried 1 load resistor, 2 load resistors, no differnece.
Disconnected the battery to reset the master control, no help.

Any ideas?

TIA,
Charlie

_____________________________

It's hard to kiss the lips at night, that chew your ass out all day long!

2007 FLHTCUI - BLACK & CHROME

Post #: 1

RE: Alarm light stays on.... - 5/10/2008 7:35:56 PM

rjrivero

Posts: 298
Joined: 10/4/2007
Status: offline

You need a load equilizer. You're bike thinks you have blown a bulb because of the decreased resistance in the circuit with the LED's.

You're best bet is a biketronics smart equilizer. The resistors that you put in line generate heat as they simulate load. Who needs that?

RJ

_____________________________

Every Revolution gives birth to a nation. The Revolution is HERE.

(in reply to cfmii11)

Post #: 2