Ok so I was able to get the codes off of my bike but now need help figuring them out.

OK under the first setting:

P: Carb code P0373= CKP sensor intermittent carb. CKP being crank position sensor.
Does that mean I need a new crank position sensor?

S: turn signal was clean of codes

SP: speedo code U1016 the only one I think pertains to me is loss of vehicle speed
I have been told that I am running about 10mph slower than my speedo says.
How do I fix that?!?!

T: tach code U1016 the same as speedo: loss of vehicle speed.
How do I fix that?!?!?

All of this started after I had the bike tuned with the TC88A. Could this be the problem? Can I take it to the dealership without them voiding my warranty for the ignition?


Thanks in advance for any help.
Eric

__________________
'06 883R/1200 - 78HP & 71TQ
[SE 1200 heads, 1200 cylinders, 1200 pistons 10:5:1, SE .551 cams,
Daytona Twin Tec Ignition, SE A/C 180 main, 45 slow, SE II exhaust]

Do you use a pressure washer to clean your bike? Check your connector,you may have gotten water in it.

__________________
Ride what you want.Not what someone else says you should.

No, no pressure washer. What connector are you talking about, the connectors for the speedo and tach?

__________________
'06 883R/1200 - 78HP & 71TQ
[SE 1200 heads, 1200 cylinders, 1200 pistons 10:5:1, SE .551 cams,
Daytona Twin Tec Ignition, SE A/C 180 main, 45 slow, SE II exhaust]

any suggestion?

__________________
'06 883R/1200 - 78HP & 71TQ
[SE 1200 heads, 1200 cylinders, 1200 pistons 10:5:1, SE .551 cams,
Daytona Twin Tec Ignition, SE A/C 180 main, 45 slow, SE II exhaust]