Cruise Control DTC Chart
Login  | |
|
|
|
|
|
RE: Cruise Control DTC Chart - 5/18/2006 8:49:03 PM
|
|
|
dyna2319
Posts: 198
Joined: 4/14/2006
From: Northern VA
Status: offline
|
SH Bob,
The sheets need to be centered a little better I can't read what they say it is difficult to follow what is happening when viewing the files. Are there three blocks on the sheet? I have yet to figure out how to post pictures correctly myself yet. Will need to spend an evening testing it out myself.
Dyna 2319
06 FXDWG/I
|
|
|
|
|
RE: Cruise Control DTC Chart - 5/29/2006 9:05:58 PM
|
|
|
Coaster
Posts: 4632
Joined: 9/25/2005
From: Pittsburgh
Status: offline
|
Had to look around a bit but thought there was some good info I saw on this. Try this link http://www.hdforums.com/m_104421/tm.htm
|
|
|
|
|
RE: Cruise Control DTC Chart - 9/17/2007 4:39:46 PM
|
|
|
HDroadking02
Posts: 11
Joined: 9/16/2007
Status: offline
|
My bike is showing a232 and a 242 code what and where do i need to look to see whats wrong? Thanks
< Message edited by HDroadking02 -- 9/17/2007 5:06:27 PM >
|
|
|
|
|
|
|
RE: Cruise Control DTC Chart - 10/12/2007 7:56:42 AM
|
|
|
AcidRayn
Posts: 901
Joined: 2/4/2006
From: Toms River, NJ
Status: offline
|
okay, ive been having a problem with mine. so here goes.
o3 rkc
yes i have a service manual and can read/understand it, no, i do not have the electrical manual (loaned it to a friend?)
left on off switch has red power light
at first, it would work, come on, and then shut off for no reason
at times, it would work for a bit, then go off, kinda the problem was intermittent
now it wont work at all
i did the code check, im getting a 112 throttle roll off
i read the section on the CC, but, what should i look for? from my reading, i need to check the throttle cables and idle cable which comes from the cruise module? i need to check the module for oms, (im an electrical contractor, i have and know how to use the meter), and adjust the cable if needed?
things ive done since before it broke
i put on a seat, gently moved the cable plug under there to accomadate my new backrest
put on grips, (could throttle cable adjustment be affecting this?)
adjusted my handle bars, but cc not working before this
correct me if im wrong, o, please poor shovelheadbob, please guide me with your vast wisdom :)
< Message edited by AcidRayn -- 10/12/2007 8:05:29 AM >
|
|
|
|
|
RE: Cruise Control DTC Chart - 10/12/2007 8:02:32 AM
|
|
|
Hdbiker1450
Posts: 1553
Joined: 6/19/2006
From: Lebanon, Missouri
Status: offline
|
I installed the cruise last May on our 02 RK. Works wonderfully well. However, while vacationing in the Gulf, we found that while the cruise is engaged, if you hit a rather large bump in the road, the cruise will automatically disengage. Not sure if this is a built in safety device or what.
_____________________________
|
|
|
|
|
|
|
|
|
|
|
RE: Cruise Control DTC Chart - 10/14/2007 1:56:47 PM
|
|
|
AcidRayn
Posts: 901
Joined: 2/4/2006
From: Toms River, NJ
Status: offline
|
okay, update
i check continuity at the cc module across the 2 wires my manual calls out, it is infinity, which it should be in a closed throttle position.
when i twist the throttle, it stays at infinity, this is bad
i checked it at the roll off switch, which seems to have some physical damage, probably from when i laid it down last year
i unpluged the connectors, got the same readings, always open
now, i moved the switch connectors, kinda twisted the whole switch so the 2 sta-kon connectors were pointing down, now i get continuity across those 2 connectors.
so, do i assume the roll off sw/idle cable is NG and replace it?
is there a way i can jump out the connections and get the cc to work so i can be sure it is the cable before replacing it?
like, if i put a temp toggle switch and connect it accross the connectors that go to the roll off sw, i leave temp sw off, then ride the bike, and then flip sw so it has continuity, should the cc work? or does the cc get other data from other places such as the ecm or tach?
i'd like to trouble shoot all of it before i start ordering anything.
it would pizz me off to no end to take the time to replace the cable only to find out something else is bad
|
|
|
|
 Today's Posts
Most Active Topics
Make A Donation
Forum Rules & FAQ
RSS Feeds
Advertising Info
|
Contact Us |
Advertising |
Motorcycle Directory |
About HDF |
Archive |
Link To Us |
Sitemap |
Harley Davidson Links |
Legal |
Privacy Policy |
© Harley Davidson Forums
HDForums.com is not affiliated with or endorsed by Harley Davidson, Inc.
|
Printable Version
