Alarm Key Fob Assignment

Harley Davidson Forum

Sponsors

Harley Davidson History

Alarm Key Fob Assignment

Printable Version

Harley Davidson Forums >> Do It Yourself Help Forum >> Engine Diagnostics , Alarm, and Fuel Injection Issues >> Alarm Key Fob Assignment

Page: [1]

Message

<< Older Topic Newer Topic >>

Alarm Key Fob Assignment - 6/28/2005 3:49:30 PM

HDF Tech

Posts: 14559
Joined: 5/14/2005
Status: offline

This must be done when you buy a new key fob for the alarm if you loose one.

I assume you know your personal entry code using the directional switches and the key switch to activate , if not , it's in the owners manual.

If you never set the code, its 7-7-7-7-7

1. Set run switch to off
2. ign to acc
3. hold both turn sigs till lights flash
4. use left turn signal to enter number by pushing 7 times
5. use right turn signal as enter key
6. repeat until all 5 are entered and you hit enter

lights should flash and you should be OK.

KEY FOB ASSIGNMENT

The key fob on TSSM motorcycles must be set so it will operate the alarm system on the vehicle.
This assignment must be completed with no pauses between steps greater than 10 seconds.
Turn the ignition OFF after all key fobs have been assigned.
The programming mode will also exit after 60 seconds has elapsed without detecting any fob signup messages
or turn signal switch activity.
Two key fobs may be assigned to the TSSM.
The first successful attempt to program a fob will disable all previously assigned fobs.
If a second fob is to be programmed, it must be done in the same programming sequence as the initial fob.