hey mack

fxdxsteve · #1 08-01-2005, 02:59 AM

http://cgi.ebay.com/ebaymotors/GENUI...64670347QQrdZ1

I don't kow how to put a link but if you copy and paste into the address thin there's a set of silver barrels cheap

stevegy

pilot1996 · #2 08-01-2005, 03:32 AM

Thanks.

I put a bid in, if I win them, I'll take it from there. I don't know what else I need to do this, but I have to win them first. I may need to get with you to find someone to grind them out...

Mac

fxdxsteve · #3 08-01-2005, 03:54 AM

no problem

fxdxsteve · #4 08-01-2005, 04:20 AM

I sent a couple of emails out to see if I could find a shop in your area probably find one around phoenix they have to have the torque plates.luckily there's a growing custom bike industry in the phoenix area

pilot1996 · #5 08-01-2005, 11:44 AM

Thanks again Steve. I'm not sure what they are worth, I was just outbid...I need to do a little research.

Mac

HDF Tech · #6 08-01-2005, 11:57 AM

Mac

Here's a place , don't know how close it is to you, they have a pretty good rep http://www.motorcyclemachine.com/

pilot1996 · #7 08-01-2005, 12:03 PM

Good link...what do you think a set of used stock jugs is worth, and where can I find out?

Mac

John TN · #8 08-01-2005, 01:57 PM

Are you doing a 95" there Mac?

John TN

Tripper · #9 08-01-2005, 02:16 PM

Mac, looks like Short Block Charlie's can bore out your stock cylinders to 95/98 so unless you're going to something larger use your old ones.

pilot1996 · #10 08-01-2005, 06:44 PM

I'm trying to go to 95". I'd like to buy a set of used jugs, have them bore them out and take it from there...not sure what a decent price is...I'm kind of watching the auction go over at Ebay and waiting for someone who knows what the might be worth. I'll auction mine off once the job is done.

So, 95", want to port and polish, change the cams...and not sure what else...trying to figure out what these jugs on Ebay are worth.

Mac