I've thought about it, might do it later on.

 

Would someone have a check on this for me?

I'm really wanting to get these bars

The 1" clamp area says 5 1/8
I measured my stock top clamps as 5 1/8

However the link doesn't like a 2019 heritage as fit
will these 12 inch bars fit my 2018?

https://www.denniskirk.com/drag-spec...V4a9rTP8d91998

 

I swapped out my 1 1/4 bars for 1 1/2 and changed the riser. I think the thick fork tubes and slider covers called for ticker bars.

Before with 1 1/4




After with 1 1/2

 

Huge fan of that low profile seat mate, I've sent photos of your bike to my trim guy to modify my original seat to look more like yours!

 

Thank you very much Birtyyy, I really appreciate the kind words!!! Thank you!!
I just ordered Rick's 200 rear fender with seat pan last night. They should be here in the next two weeks or so? Im looking to add a 200 rear wheel to my slim so Im going to have to form and recover another seat. I would love to see some pics when yours is finished.

 

that is fire , do you got a a link to that set up I would love to do this to my low rider fxlr,i actually like your stock fender if it would had fitted my low rider I would have asked you to sell it to me but I dont think it works on my bike

 

Rode her home this evening from the initial 1000 mile dealer service.

Last week I installed the Memphis Shades headlight extender block so my light is up front on my batwing fairing.

Also installed some new bars - stainless! A bit too low tho. Will be adding some pullback risers to get it perfect.

Final pic is from last nights approach into DC.

 

looks really good , I would stick a nice compact sound system in there.

 

I bought it hello everyone!

 

Welcome and NICE BO!