This post doesn't really belong in audio but...
 

I like this forum better than any other :icon_dance-tap:

Get my cast off tomorrow, it's been a hell a long 6 weeks for sure!

Was doing the last few items left to button up on the bike and WHAMMO! here's a clue to what I was doing for the last 2 hours :icon_bricks:

Care to guess what this little gem does?

https://cimg8.ibsrv.net/gimg/www.hdf...0313c296be.jpg

Inside the cast scratcher.

nice guess but it's for the bike not me. Besides, cut up wire coat hanger works best :p

Ign switch then would be my real guess

lol yeah, fun times

Been there done that. I got by using a big flat head screwdriver.

Screw driver for me as well

What? you have the Ignition tumbler out, and its out of sync? So you need the tool to get the tumblers back in alignment to pop it back in, enlighten me please :icon_rolleyes:

some searching and I found this:

That is the correct way in the video
and Bunker you prob have a tool built that will work
he describes the lock button on the bottom of the switch very well
I just went through all this on my bar change.
Also a good time to spray lube that switch underneath while its off, Mine had a little surface rust. I worked it back and forth with the key in it