System almost there Arc moto 602s , AD CX62 Arc 600.4
#1
System almost there Arc moto 602s , AD CX62 Arc 600.4
Many thanks to this forum for helping me put together a great system. The problem is I dont think I am getting top performance from the system because the AMP is not dialed in due to my lack of knowledge. The moto 602,s are in the lowers and the fairing is running the AD Design CX62. The amp is ARC 600.4 and the head unit is a Sony Sony MEX 70 Bt. The Bike is a 2013 Ultra. I have some inexpensive pioneer 6.5 speakers in the rear pods connected directly to the head unit to add a little sound for the wife.
Here are my current settings. Thanks
Here are my current settings. Thanks
Last edited by Riveroger; 09-20-2017 at 10:14 PM.
#2
#3
Originally Posted by Tailwind
I would set the crossovers in the 80-85 range. Look like they are cranked all the way to the left aha 50 which is gonna get u some early distortion. Those ADs take a knee (distort) pretty early in the game if crossed below 85.
T.
T.
#4
#5
Originally Posted by Riveroger
Yes getting the distortion at 50 even with the gain set low , will bump up to 80. What would be good for the 602,s . Would high pass work better than full pass?
HP allows u to filter out the lower freqs that would cause distortion early in the game associated with the pretty hostile sled audio environment. If u set 80 u r filtering out the freqs less than 80. On a sled and with typical coax and components, the rule of thumb is 80-85 is a great place to start.
T.
#6
Yes, run high pass as SB mentioned. I thought u were running HP but my head was up my ****.
HP allows u to filter out the lower freqs that would cause distortion early in the game associated with the pretty hostile sled audio environment. If u set 80 u r filtering out the freqs less than 80. On a sled and with typical coax and components, the rule of thumb is 80-85 is a great place to start.
T.
HP allows u to filter out the lower freqs that would cause distortion early in the game associated with the pretty hostile sled audio environment. If u set 80 u r filtering out the freqs less than 80. On a sled and with typical coax and components, the rule of thumb is 80-85 is a great place to start.
T.
Thread
Thread Starter
Forum
Replies
Last Post