Trying to decide on replacement horns. These or may be DD. Which do you like?

Thanks

 

The mmats horn sounds just fine. I would choose it for SQ over the DD, but the DD is smaller and will fit in more configurations. Where are you going go mount? If in guage holes, I'd choose mmats.
m

 

Yea in the gauge holes. Im leaning toward them. Should match up nice with my drivers. Thanks for posting.

 

if you are going guage holes, then to me it's a no brainer. let us know how they sound when you get it set up!!
have fun
m

 

Will do. I just ordered another rebuild set for my audiopipes, and will order the mmats soon.

 

Well for about half the price you can do the Cadence XT60's. they play a little lower are a little more sensitive and are 3ohm.
They are the same dimensions.

 

Do the 26t's have a built in crossover like the 35t's?

 

Mine were not "built in" per se.. the crossovers came with the set and I had to solder them inline if thats what you asking...

 

Just solder one leg of the cap on to each wire?

 

I am not sure of your set up.. but it really doesnt matter to be honest but I put 1 leg on the + side of tweet and the other + side of amp wire or speaker just depends on your setup