Dyna Glide Models Super Glide, Super Glide Sport, Super Glide Custom, Dyna Glide Convertible, Super Glide T-Sport, Dyna Glide Police, Dyna Switchback, Low Rider, Street Bob, Fat Bob and Wide Glide.
Sponsored by:
Sponsored by:

No spark at the plugs

Thread Tools
 
Search this Thread
 
  #1  
Old 10-21-2017, 11:08 AM
MORT666's Avatar
MORT666
MORT666 is offline
Advanced
Thread Starter
Join Date: Apr 2016
Location: bridport dorset u.k
Posts: 87
Received 3 Likes on 3 Posts
Question No spark at the plugs

Hi from the U.K .Help my year 2000 wide glide has no spark at the plugs,i'am trying to find the the plug with red and black wires which disappears at the starter to test the crank position sensor.
 
  #2  
Old 10-21-2017, 11:36 AM
JayStronghawk's Avatar
JayStronghawk
JayStronghawk is offline
Ultimate HDF Member
Join Date: Dec 2007
Location: Lake City, Florida (Native)
Posts: 9,255
Received 279 Likes on 214 Posts
Default

Shutoff Switch .. ( Kill Button )
 
  #3  
Old 10-21-2017, 12:09 PM
MORT666's Avatar
MORT666
MORT666 is offline
Advanced
Thread Starter
Join Date: Apr 2016
Location: bridport dorset u.k
Posts: 87
Received 3 Likes on 3 Posts
Default

WISH it was.
 
  #4  
Old 10-21-2017, 01:13 PM
seniorsuperglideE8's Avatar
seniorsuperglideE8
seniorsuperglideE8 is offline
Supporter

Join Date: Jan 2007
Location: along the shore of Mishigami
Posts: 15,674
Received 4,307 Likes on 2,356 Posts
Default

Crank position sensor plug on my 2002 FXD is under the frame, Right hand side as you are sitting on the bike.
 
  #5  
Old 10-21-2017, 01:27 PM
MORT666's Avatar
MORT666
MORT666 is offline
Advanced
Thread Starter
Join Date: Apr 2016
Location: bridport dorset u.k
Posts: 87
Received 3 Likes on 3 Posts
Default

Thanks mine goes under the motor disappears by the start but there is a plug with a red wire and black under the seat ?
 
  #6  
Old 10-21-2017, 01:28 PM
cggorman's Avatar
cggorman
cggorman is offline
Extreme HDF Member
Join Date: Jun 2014
Location: NW Ohio
Posts: 11,448
Received 2,291 Likes on 1,710 Posts
Default

Looking at my 99 wiring diagram, the crank sensor has two wires, red and black. Both terminate at the ECM. Gray plug. Pins 5&6. There is a connector in between. It's shared with the cam sensor and can be found under the frame near the front of the engine.

Thw cam sensor is three wires: red/white, black/white, & green/white.

Don't forget to check the banl angle sensor, behind the battery on the rear down tubes. Three wires, light-green/gray, black, & gray.
 
  #7  
Old 10-21-2017, 01:50 PM
MORT666's Avatar
MORT666
MORT666 is offline
Advanced
Thread Starter
Join Date: Apr 2016
Location: bridport dorset u.k
Posts: 87
Received 3 Likes on 3 Posts
Default

Thanks i will look again tomorrow.
 
  #8  
Old 10-21-2017, 01:52 PM
MORT666's Avatar
MORT666
MORT666 is offline
Advanced
Thread Starter
Join Date: Apr 2016
Location: bridport dorset u.k
Posts: 87
Received 3 Likes on 3 Posts
Default

Not getting codes also.
 
  #9  
Old 10-22-2017, 01:23 AM
MORT666's Avatar
MORT666
MORT666 is offline
Advanced
Thread Starter
Join Date: Apr 2016
Location: bridport dorset u.k
Posts: 87
Received 3 Likes on 3 Posts
Default

No plug under the motor.
 
  #10  
Old 10-22-2017, 02:47 AM
K9F's Avatar
K9F
K9F is offline
Road Master
Join Date: Dec 2016
Location: Bournemouth United Kingdom
Posts: 1,051
Received 393 Likes on 252 Posts
Default

Hi Mort it is this forum I gathered most of the information I posted for you on the UK forum, same thread. You are now in the best place!
 


Quick Reply: No spark at the plugs



All times are GMT -5. The time now is 11:09 PM.