Help! Rear Turn Signal Wires
#1
Help! Rear Turn Signal Wires
So I de-pinned my rear turn signals and made the mistake of not taking a picture of the wires. My 16 Street Bob has the small plugs where the wires running to the turn signal have a grey, purple, and a blue and on unused slot. The other plug has blue with red stripe, solid blue, blue with purple stripe, and solid black. Can anyone tell me how these go?
#2
Nevermind, I got it figured out... ONLY to find that Harley made the turn signal wires TOO #ucking short! I'm in the middle of relocating my turn signals back so that I may install saddle bags. I do not want to cut and splice wires, that's why I de-pinned the plugs. With the signals relocated back a few inches, the signal wires won't even make it into the area under the seat where all of the harnesses meet. Seriously, who cuts wiring exact length. WTF
#3
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 147,588
Received 47,745 Likes
on
18,544 Posts
#4
#5
The following users liked this post:
Uncle Larry (03-17-2019)
#6
Join Date: Jan 2007
Location: along the shore of Mishigami
Posts: 15,674
Received 4,284 Likes
on
2,350 Posts
When I was building high end boats we were taught to leave a service loop so that ends or switches could be accessed. We had one individual that didn't want to adhere to that policy and the techs out in the marinas had some good names for this guy. Glad you were able to get some wire to the plugs and effect a good repair.
#7
When I was building high end boats we were taught to leave a service loop so that ends or switches could be accessed. We had one individual that didn't want to adhere to that policy and the techs out in the marinas had some good names for this guy. Glad you were able to get some wire to the plugs and effect a good repair.
BUT under fenders you don't want extra wire, that's why the exact length .
Thread
Thread Starter
Forum
Replies
Last Post
Mccula
Electrical/Lighting/Alarm
5
09-20-2018 06:45 PM
codykucich
Electrical/Lighting/Alarm
1
06-28-2012 02:25 PM
Matt115
Ignition/Tuner/ECM/Fuel Injection
8
03-31-2006 04:13 PM