Tach Install issue
Hooking up a tach on 2007 streetbob . have found you can get a sig from #3 hole on ECM , but just wanted to see if anyone else with an 07 did this the write up was for an 06 , dont see why it wont work but just wanted to check .
 \\; Slinger |
RE: Tach Install issue
I did it on an 08 and it worked.
GPM  \\; |
RE: Tach Install issue
i did on my 06 i do not see why you would not on a 07, the ECM did not change just the program... should work just fine brother
|
RE: Tach Install issue
ECM connector terminal 3 works for \\;my '07.
|
RE: Tach Install issue
good deal thats what i thought just wanted to check before i rip into it ,
 \\; thansk fellas  \\; Slinger |
RE: Tach Install issue
for some strange reason, I couldn't get a signal from the #3 on the ECM on my '06 WG. \\; Finally got it from the #3 off of the speedo and it works great.
 \\;  \\;  \\;  \\;  \\; http://i96.photobucket.com/albums/l1...e/DSC03018.jpg |
RE: Tach Install issue
thanks gman
 \\; if i dont get it from there I will try it from the speedo  \\; thanks for the heads up  \\; slinger |
RE: Tach Install issue
I got the signal right from the speedo also. \\; Everything works great.
 \\; 07 FXD |
RE: Tach Install issue
gman - Tell me a little about the fork brace you show. I like the look and am wondering if you noticed any handling differences with it on. Thanks
|
RE: Tach Install issue
I just put a tach on my 08 FXDC . Power was obtained from the Orange and White at the speedo you can get the ground at the same plug on the black and grey. My other wire ( pulse )went to the blue and red down at the Ignition coil plug .
 \\;\\\\\\;  \\;\\\\\\; |
All times are GMT -5. The time now is 03:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands