Help me fit mojo's C & C seat over my powercommander
#1
Help me fit mojo's C & C seat over my powercommander
I purchased a seat from "MOJO" in this forum, a C & C low profile. He sent it to me superquick for a superdeal and I just tried to put it on the old Street Bob. Of course it will not fit with my PCIII under there and it is about 1.5 inches too high from the fender screw hole. Any suggestions? I don't know of anywhere else to put the PCIII. The stock Bob seat has a nice relief/recessed area under it, but the C & C seat is flat on the bottom. I'd rather not have to send it back tomorrow, so any advice will be extra nice. B.I.T.2.T.
#2
#3
#4
RE: Help me fit mojo's C & C seat over my powercommander
Hello Try 2 Try
Is the installation different on the Street Bob? I have a 06 Wide Glide and my PCIII is installed in the electrical caddy, there was an open space under the ECM module. I assume that the smart siren would be installed there if I had one. The installation instructions that were in the box said to install it there.
Zyklon
Is the installation different on the Street Bob? I have a 06 Wide Glide and my PCIII is installed in the electrical caddy, there was an open space under the ECM module. I assume that the smart siren would be installed there if I had one. The installation instructions that were in the box said to install it there.
Zyklon
#5
RE: Help me fit mojo's C & C seat over my powercommander
It will fit under the seat. Pull all the wiring harnesses out and put the pcii on the right side vertically. the wiring will tuck back in around it or behind the battery.
That is the corner sticking up to the right of the brass bolt hole.
[IMG]local://upfiles/8936/D66335F8656541A383E9E46C291DB30E.jpg[/IMG]
That is the corner sticking up to the right of the brass bolt hole.
[IMG]local://upfiles/8936/D66335F8656541A383E9E46C291DB30E.jpg[/IMG]
#6
#7
RE: Help me fit mojo's C & C seat over my powercommander
I pulled the harness and repositioned the main clip and dang if it didn't all fit just fine. When I first tried that when I got the seat in the mail all the wires and clips were hung and so mashed in I thought it would never happen, but after a little muscle and some sweat from my forehead dripping onto the wires they fit in just fine. I feel like I should be paying to be a member of this forum. Thanks for the advice, on an easy fix.
Trending Topics
#8
Thread
Thread Starter
Forum
Replies
Last Post