Bad Bob is home

 

Very nice!

 

Let me be the first to whine about the reflectors. Bike looks nice.

 

Is that the 120R motor?

 

Welcome home Bad Bob. Looks good!

 

yea whats the best way to remove the reflectors without buggering the paint?

 

Little bit of heat at a time and then pop them off. Use a lettle bit heat and a pop sicle stick to get mot of the tape off. Then a little wd40. The same for the tank emblems but remember to just take your time.

 

I used a hair dryer to heat my reflectors up, then used several strands of fishing line pulled between the reflector and surface to remove them. Use a few strands of the line, as one will break. And wear gloves to keep your hands from getting buggered by the line.

 

yea thanks dean and johnny, i`ll give it a try. i know them throttle cables were a pain in the ***. the factory ones came out hard, but when i installed the burleys and had em on the wrong side of the tubes i had to pull em back out and they were a @#%$!&^$.