I pulled my canister of the front and pulled the lines(keeping everything in case I need to put it back at some point) and behind the coil is the jct.where the lines come together.There is a couple wires going to this....what are these for ?I left the tank vent and caped the intake port, but I'd like to know what the wires go to...thanks in advance

 

I believe there is a tip over sensor located there.........

If your bike tips over this shuts the bike down for 10 minute's after the bike is upright, so it will not start.........

Live Free = Ride Free...............

 

The wires go to a purge valve. Leave it hooked up, but cap off the vacuum line ports, other wise it will throw a check engine light. I ditched all my smog sh*t, and havent had an issue.

 

Thanks Mike. ..I'll cap em off