Electrical/Lighting/Alarm Having electrical problems? Discussion on everything electrical and lighting systems.

2008 Road King Cleaned Throttle body electrical connector, now it wont crank?

  #1  
Old 07-16-2017, 09:33 AM
trigger1911's Avatar
trigger1911
trigger1911 is offline
Tourer
Thread Starter
Join Date: Jan 2007
Posts: 279
Received 16 Likes on 11 Posts
Default 2008 Road King Cleaned Throttle body electrical connector, now it wont crank?

So my 2008 FLHR Road King went into safe mode yesterday. Rode home in first gear and parked it in the garage. Read the forums on cleaning the connector behind the air cleaner and applying dielectric grease and reassembled. Now it wont crank but the starter relay in the fuse box clicks. I also have no turn signals or 4-ways but they flash for the security system. I also have no horn and brake lights, but the headlights, taillights and the battery are all good. The most confusing thing is that I have a Hoppe Quadzilla fairing with a radio and that also wont come on and it is not even connected to any of the electrical system, just wired straight to the battery. I double checked each fuse and relay and they are all good. The only thing I can figure out is that I had to lift up the gas tank to get the connector apart. If I have the ignition on and I lift up the tank everything goes blank until I lower it to a certain point. I also think I put too much grease on the terminal on the throttle body side of the connector so I used a metal screwdriver to scrape some out without unplugging the negative battery lead. So much for riding on the one day I had off in 2 weeks!
 
  #2  
Old 07-16-2017, 10:30 AM
trigger1911's Avatar
trigger1911
trigger1911 is offline
Tourer
Thread Starter
Join Date: Jan 2007
Posts: 279
Received 16 Likes on 11 Posts
Default

I found the problem!!!! The wiring harness under the dash started to come off because the retaining clips were worn. It was just loose enough to come off one side. I put a zip tie around it and everything works fine.
 
Attached Thumbnails 2008 Road King Cleaned Throttle body electrical connector, now it wont crank?-20170716_105315-1-.jpg   2008 Road King Cleaned Throttle body electrical connector, now it wont crank?-20170716_105323-1-.jpg   2008 Road King Cleaned Throttle body electrical connector, now it wont crank?-20170716_105335-1-.jpg  
The following users liked this post:
Dan89FLSTC (07-17-2017)
  #3  
Old 07-17-2017, 10:55 AM
larsfum's Avatar
larsfum
larsfum is offline
Stellar HDF Member
Join Date: Jan 2009
Location: On a Lake, not far from the Gulf
Posts: 2,577
Received 458 Likes on 323 Posts
Default

Thanks for reporting the answer. You may help someone else down the road.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
albieback
Touring Models
2
05-15-2012 07:21 AM
Pursuit
Touring Models
7
01-15-2011 12:05 PM
Herky737
Touring Models
5
07-23-2010 06:20 PM
j.manns83
Electrical/Lighting/Alarm
2
05-20-2009 04:36 PM
glblock
Ignition/Tuner/ECM/Fuel Injection
5
03-31-2008 06:37 PM


Thread Tools
Search this Thread
Quick Reply: 2008 Road King Cleaned Throttle body electrical connector, now it wont crank?



All times are GMT -5. The time now is 02:45 AM.