Engine Mechanical TopicsDiscussion for motor builds, cams, head work, stripped bolts and other engine related issues. The good and the bad. If it goes round and around or up and down, post it here.
Careful..... his 40,000 feedbacks are only 99.9% positive. There's 1 guy out there somewhere not happy
__________________________________________________ ____ For ROCKOUT information & purchasing please click the LINKSbelow... For all Twin Cams and Evo Big Twins & Sporsters
__________________
NO, they DON'T all do that!
ROCKOUT rocker shaft inserts... make the tapping STOP! From the guy that FOUND and CURED the problem NO ONE ELSE COULD, thank you for your support! Ordering & info http://www.rockout.bizOn ebay! ...CLICK HERE Also on amazon.com...
Careful..... his 40,000 feedbacks are only 99.9% positive. There's 1 guy out there somewhere not happy
__________________________________________________ ____ For ROCKOUT information & purchasing please click the LINKSbelow... For all Twin Cams and Evo Big Twins & Sporsters
lol, yeah. the price difference was throwing me off. it's $144 on the heartland site. the address of heartland and the ship from address match up though.
one question
how do you keep the bearing from spinning in the case as it goes in ?
or does it the tool spin on the bearing face ?
seems like there may be some binding
You'll find that when pulling the bearing, as you apply more & more pressure..... there's like a moment where time stands still, the earth stops rotating, dems and reps get along, you think something is going to break, then..... POP it comes free lol.
__________________________________________________ ____ For ROCKOUT information & purchasing please click the LINKSbelow... For all Twin Cams and Evo Big Twins & Sporsters
I have this really cool bearing puller/installer. It's this all in one tool that someone was making a while back and selling them here and on HTT I believe. I purchased it about 6 years ago and have used it 3 times and it works like a champ. For the life of me I can't remember who the hell was selling them though.
I have this really cool bearing puller/installer. It's this all in one tool that someone was making a while back and selling them here and on HTT I believe. I purchased it about 6 years ago and have used it 3 times and it works like a champ. For the life of me I can't remember who the hell was selling them though.
But as it goes in? the critical part perhaps putting the bearing in the freezer for a few hours prior would help ease it ?
Always a good idea. Freeze bearing and liberally apply assembly lube to bearing and boss. Not a "have to" but it will facilitate the bearing install and helps to avoid getting the bearing started in crooked.
04-21-2017, 07:40 PM
