Need Help Building More Torque
#11
#12
My buddy picked up a 2006 Street Glide which has the 88ci twin cam, and the cv carburator. The previous owner had S&S 510 gear drive cams installed, a stage-1 air filter, and Rinehart true dual exhaust. The carb was re-jetted and it actually runs pretty good.
Here's the issue:..... my buddy is a pretty big man. He's 6'4" and weighs about 320 lbs..... therefore we have a power to weight ratio situation. Torque moves mass...which is why I'm focusing on trying to build a little more of it. Unfortunately I am dealing with a budget here. My first thought was to go bigger with the cubic inches, and get him a 95" big bore kit, but I'm wondering if that alone is going to do that much?
If my budget was say: $1000 ….what would be the recommendation to try and get him a little more torque? I realize $1000 isn't much to work with,....but I'm hoping it's enough to wake it up a little more. Whether it's bigger cams, some head work??? Just not sure what the best route to take is.
Thanks for your input -
Here's the issue:..... my buddy is a pretty big man. He's 6'4" and weighs about 320 lbs..... therefore we have a power to weight ratio situation. Torque moves mass...which is why I'm focusing on trying to build a little more of it. Unfortunately I am dealing with a budget here. My first thought was to go bigger with the cubic inches, and get him a 95" big bore kit, but I'm wondering if that alone is going to do that much?
If my budget was say: $1000 ….what would be the recommendation to try and get him a little more torque? I realize $1000 isn't much to work with,....but I'm hoping it's enough to wake it up a little more. Whether it's bigger cams, some head work??? Just not sure what the best route to take is.
Thanks for your input -
Not the cam we'd use for a this, but it WILL bring the power up dramatically.
I believe our Facebook has a before/after of this, but with with a set of our Stage II Heads.
Scott
__________________
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
Thread
Thread Starter
Forum
Replies
Last Post