Any way to get 1 Andrews EZ install pushrod?
#1
Any way to get 1 Andrews EZ install pushrod?
Hey guys,
Anybody know where I can get 1 Andrews EZ install aluminum adjustable pushrod (exhaust valve length) for an evo? Was putting a new set in with my new cam and lifters yesterday, and didnt have this one seated fully, bent it turning over the motor by hand. Really annoyed I did that. I only see them available in the pack of 4, but my others are new and fine. Don't want to buy another $170 set unless I have to. Thanks!
Anybody know where I can get 1 Andrews EZ install aluminum adjustable pushrod (exhaust valve length) for an evo? Was putting a new set in with my new cam and lifters yesterday, and didnt have this one seated fully, bent it turning over the motor by hand. Really annoyed I did that. I only see them available in the pack of 4, but my others are new and fine. Don't want to buy another $170 set unless I have to. Thanks!
#2
Join Date: Jul 2010
Location: Murrells Inlet SC, Cape Vincent NY
Posts: 791
Likes: 0
Received 163 Likes
on
102 Posts
The following users liked this post:
TwiZted Biker (01-21-2018)
#3
Join Date: Oct 2015
Location: Pine Flat Dam/South Bay Area, CA
Posts: 11,490
Received 19,498 Likes
on
6,629 Posts
#4
No I don't think I bent a valve. I'm not positive I had the pushrod centered on the rocker, it may have slipped off to the side. I was a total dumbass and didn't check it. I turned the motor over very slowly with the rear wheel, trans in 5th gear. The pushrod bent right away, it took all the damage. Didn't even have any weird resistance on the wheel at all, I didn't even notice something was wrong for a minute. Stupid, stupid mistake.
I'll call Andrews and check, worth a shot.
Thanks!
I'll call Andrews and check, worth a shot.
Thanks!
#5
Thread
Thread Starter
Forum
Replies
Last Post