Winter Project : ElectraGlide Swingarm, Top End and Bags
#172
#173
#174
#175
The following users liked this post:
GREENOHAWK69 (01-15-2019)
#176
#177
#178
That's not oil, it's seafoam!
Here's a question: The factory rocker bolt setup was a fiber washer under a steel washer. Had the devil's own time getting the old fibers off, too. Anyway, the Cometic kit came with fiber washers AND copper washers, and no instructions. Lacking a better idea, I sandwiched it all together: fiber then copper then steel. Any experience with these? Any reason the sandwich is a bad idea?
Here's a question: The factory rocker bolt setup was a fiber washer under a steel washer. Had the devil's own time getting the old fibers off, too. Anyway, the Cometic kit came with fiber washers AND copper washers, and no instructions. Lacking a better idea, I sandwiched it all together: fiber then copper then steel. Any experience with these? Any reason the sandwich is a bad idea?
#179
The following users liked this post:
0maha (01-13-2019)
#180