I've talked to Zippers in Maryland. But I'm open to suggestions. They could do heads simllar with their 80/80 kit. My bike has EV27 cam and also a Mikuni carb

 

Where do you live?
On the east coast You have Vee-twin (Kirby ) in Florida and Hillside (Scott) upstate as well as WFO Larry Not sure where he is but all good porters... I know I've heard Scott talk of Zippers as well....

 

The freezing state of Maine

 

130k and only doing the top end? i'm not implying that you should do the bottom too.....i'm in the same situation mile wise with my 85. just wondering what your thoughts are.

 

Good point!
Make sure you check the rods per FSM instruction.
You can do this with the engine in bike cylinders pistons off.

 

What about Bean Big Boyz? He's in Maine. A kit of people on this forum use his calculators online.
Saying this, I'm not sure if he is still open but he's worth a phone call I'm sure.

 

All ya have to do is measure side play to know how worn the rods are..

 

I forgot about Big Boyz. I'll check em out. thanks

 

I am lost ..what calculator for what?