I just finished putting Rush 2.0 slip-ons and a SE Stage I breather on my 2009 Fat Bob. I also bought the SE Super Tuner, but I'm having a tough time finding the right base calibration for the super tuner. I'd appreciate any suggestions.

 

96", High Flow breather and Race Exhaust.... Cal 176AE106..... It's in the Calibrations Description handout in the software....

 

Thanks. That's the one I was looking at, but I wasn't sure about the 25 degree injectors. I didn't know if that was stock or aftermarket.

 

When I got home, I tried the 176AE106 file, but the software on my laptop tells me that this file isn't compatible with my ECM. Any suggestions? This process is frustrating.

 

call bloomington HD,ask for BJ,or rich hankens,both very good with the SE stuff,rich tuned owner jeff stevens to second in AHDRA destroyer (i think),and #1 in super gas
kirby
vee twin racing

 

Are you sure that the VCI firmware is updated?????

That map is for an 07-10 Shotgun/Shorty system (Softail/Dyna), All Market.....

You might not have your run switch on, or there is a bad connection....

 

The firmware on the VCI and the software on the laptop were updated.

The engine run and ignition switches were both on.

I'm wondering about the connections myself, but the software shows a good connection at the bottom left of the screen. I'll keep messing with it.

 

I noticed this morning that the ECM information field was not populated with VIN, ECM number, etc. It makes me worried that there's a connection problem or software issue. I might check with Harley tech support today.

 

I gave up, and took it to the dealer. It needed a full dyno tune anyway.