Purchased 13" a while back and finally got around to changing out. Noticed how the pipe at top of each side were not filed down and felt some sharp edges. Not going to take a chance trying to pull cables through. Good chance I will tear in to them. I sent an email to their website with pictures but never got a response back. Decided to go with a set of Factory 47 instead.
Sprink64

 

Pretty big price difference between the Holy Roller bars and the Factory 47. I had the same issue with KST bars and rough welds inside that had to be filed,

So welcome to the forum and post up some pics of your bike!!

 

 

 

They have a phone number as well, just FYI.

 

I had one set of welded Z bars in my life until the right side snapped off in my hand while riding. Ya bur ya learn. Traditional bent bars for me from then on.

 

The OP, you know, the one that started the thread? Well, this was their only post, last month.... Geez people.

 

The OP, you know, the one that started the thread? Well, this was their only post, last month.... Geez people.