|
I can't find the thread on using a Radio Shack Siren
NEVER MIND, I found it.
I did a search and can't seem to find the thread that was posted a week or so ago about using a Radio Shack siren with the HD security system instead of the HD siren. Does anyone have that wiring instructions? Thanks! |
RE: I can't find the thread on using a Radio Shack Siren
Okay, so where is it?
Hook a brutha up ORIGINAL: cutacroshorty NEVER MIND, I found it. I did a search and can't seem to find the thread that was posted a week or so ago about using a Radio Shack siren with the HD security system instead of the HD siren. Does anyone have that wiring instructions? Thanks! |
RE: I can't find the thread on using a Radio Shack Siren
The part number is 273-079 for the Radio Shack Siren and here are the instructions.
The siren from the Shack only has 2 wires (red and black), the bike has three (brown, green, and black). Strip about an inch of the wire on the siren, then fold the exposed amount in half and twist, in order to make thicker and more rigid. Then plug the siren (red) into the bike (brown) and the siren (black) into the bike (green). Be sure and keep the two apart by insulating with electrical tape. I then used some flex tube to protect the remaining exposed wire. Tip: When using electrical tape, after covering desired area, twist tape so that adhesive side is out. Then after a couple wraps twist back again and wrap adhesive side to adhesive side. This will eliminate the heat causing the tape to peal up. Siren should snug up nicely in the area where the factory one would have gone. |
| All times are GMT -5. The time now is 08:25 AM. |
© 2026 MH Sub I, LLC dba Internet Brands