Last edit by: IB Advertising
Need to soften up a leather jacket? Leather jackets are really stiff when new or can become stiff after being stored. There are a lot of different ways to soften up leather and everyone has their own technique. The most popular suggestions seem to be:
Read the full discussion below to find out what forum members are doing.
Read the full discussion below to find out what forum members are doing.
Any way to soften up a leather jacket?
#12
#14
#16
http://pecard.com/mm5/merchant.mvc?S...ode=motorcycle
pecard is made in green bay, wisconsin USA. it's all i use.
pecard is made in green bay, wisconsin USA. it's all i use.
#17
#18
#19
A "good" leather jacket shouldn't feel stiff. "Good" leather doesn't require that much break in. Cheap leather does! Having said that wear it and it should loosen up, if it starts as shoe leather it will likely end like shoe leather. My "cheap" (material not cost) leather boots haven't broken in in 4the years, my "good"leather boots broke in in less thaan 2 weeks, but like I said they didn't start out like shoe leather
The following users liked this post:
Torky_SOB (05-25-2018)
#20
Myths - Softening Leather by Chewing:
Indian women did not soften leather by chewing it. Soft and pliable leathers were prepared by chipping or shaving the hide using a stone or steel scraper prior to tanning the leather to thin the skin. This is an especially important step for buffalo hides. After the skin had been thinned, it was critical to work the hide by flexing and stretching over a rope or pole while the hide dried after tanning. For more information about this process see Preparing Robes and Hides. The photo at right is of a Cheyenne "Chipper" made of Elkhorn with an iron blade from the collection of the Museum of the Fur Trade in Chadron, Nebraska.
from link
http://www.mman.us/mythsleathersoftening.htm
Indian women did not soften leather by chewing it. Soft and pliable leathers were prepared by chipping or shaving the hide using a stone or steel scraper prior to tanning the leather to thin the skin. This is an especially important step for buffalo hides. After the skin had been thinned, it was critical to work the hide by flexing and stretching over a rope or pole while the hide dried after tanning. For more information about this process see Preparing Robes and Hides. The photo at right is of a Cheyenne "Chipper" made of Elkhorn with an iron blade from the collection of the Museum of the Fur Trade in Chadron, Nebraska.
from link
http://www.mman.us/mythsleathersoftening.htm