Top3 reasons to stay away from Heat Demon - info from an X employee
#11
#12
Well, he may be disgruntled but he could still be be telling the truth.. Considering the fact that in today's business climate the sole concern is maximizing profits no matter what it takes, it's no surprise that quality and service takes a back seat. And to what extent does the attitude of the individual worker impact a business? It's obvious to the average consumer that most workers today could not care less whether the company they work for lives or dies.The fast food industy is a perfect example of that.
The following users liked this post:
tar_snake (10-11-2018)
The following users liked this post:
SPRINGER (09-19-2018)
#14
Join Date: Jan 2011
Location: Southeast Michigan 15 Minutes East Of Hell
Posts: 147,601
Received 47,786 Likes
on
18,560 Posts
#15
If I was a prospective employer of this guy and I found something like this post in the interview/background process I'd steer clear. Sometimes people are genuinely treated poorly by employers and have a right to be angry about it. However, if I was suddenly out of a job I'd be using ALL my energy to get another one, not poor mouthing the company on the internet. OP, do you want to talk about your Harley Davidson motorcycle or riding it ?
OP, Harley puts Chinese parts on Harleys and they ain't worth a f**k; it is what it is.
Last edited by Campy Roadie; 09-20-2018 at 05:39 AM.
#16
#17
I have a Heat Demon vest that was a gift. I do ride in extreme cold sometimes in Wisconsin. It has been around awhile and sill works as it should. Companies change if they didn't they would fade away. Also have couple sets of HD heated gloves that have seen a lot of use they work well also. Just lucky again I got the package with the good stuff in it.
#18
#19
UPDATE: Receive the grip warmers Saturday, Installed Saturday night.
I have aftermarket bars and the grommet for where the wires go into the bar won't go in (bars are to thick at the dimpled area).
Deburred it well. While I had it apart I installed 8+ Throttle and idle cables (mine were a CH to short and left locked turns would increase the RPMs).
All in all install wasn't bad except for stuffing all the wire back into the bars, so far they work OK.
The kit came with a heater for TBW also. Maybe I'll figure out how to utilize it as an *** warmer.
I have aftermarket bars and the grommet for where the wires go into the bar won't go in (bars are to thick at the dimpled area).
Deburred it well. While I had it apart I installed 8+ Throttle and idle cables (mine were a CH to short and left locked turns would increase the RPMs).
All in all install wasn't bad except for stuffing all the wire back into the bars, so far they work OK.
The kit came with a heater for TBW also. Maybe I'll figure out how to utilize it as an *** warmer.
#20