Running/Removing Internal juice lines from bars
 

Hey guys,

This is my first (well second if you count the intro thread) post here, so thanks in advance for your help.

I've got a chop with internal hydraulic lines in a set of 16" apes & I want to switch out the bars, but really only have experience with the old school cable systems (so much easier). This might sound like a dumb question, but I've done stuff the hard way many times before - only to find out later that there was an easier solution...

So here's my question: What's the best way to disconnect the internals (juice front brake & clutch mostly) so that I can get them out of the old bars & swap them onto (not INTO) the new bars? Is this a massive PITA?

Thanks,
Tim