Krhome Werks plug and play harness
#1
Krhome Werks plug and play harness
Hi, I have a Krhome Works 4 wire plug and play tailer wiring harness on my 2014 street glide.
I have running lights, signal lights, but no brake lights.
When I test the plug on the bike, I don't get a solid 12 volts on the signal light wires when I press the brakes, it just stays flashing 12 volts.
Any ideas, someone said to unplug the fuse to the module to reset it, but don't have time to try it out till tomorrow.
I bought the harness last november and only just got my trailer done, so I doubt krhome werks will warranty this.
I have running lights, signal lights, but no brake lights.
When I test the plug on the bike, I don't get a solid 12 volts on the signal light wires when I press the brakes, it just stays flashing 12 volts.
Any ideas, someone said to unplug the fuse to the module to reset it, but don't have time to try it out till tomorrow.
I bought the harness last november and only just got my trailer done, so I doubt krhome werks will warranty this.
#2
Thread
Thread Starter
Forum
Replies
Last Post