thunder max Gen 111 upgrade
#1
thunder max Gen 111 upgrade
Posted this in the Thundermax sticky thread. Reposting to see if I can get more hits...
Changed to the Gen 111 up grade on Tuesday. Did the set up and the bike would not start. Emailed thunder max and was told to roll on the throttle when cranking and it started but would not idle and ran very rough. Thunder max said to change the TAC from 61 to 85. Did that and still no start unless I rolled on the throttle. Did a data collection and sent it to support. Haven't heard back from them yet. When I install the stock ECM it starts and runs fine. Any ideas? TIA...06 electra glide with 65,000 miles...=left
Trucky911
Changed to the Gen 111 up grade on Tuesday. Did the set up and the bike would not start. Emailed thunder max and was told to roll on the throttle when cranking and it started but would not idle and ran very rough. Thunder max said to change the TAC from 61 to 85. Did that and still no start unless I rolled on the throttle. Did a data collection and sent it to support. Haven't heard back from them yet. When I install the stock ECM it starts and runs fine. Any ideas? TIA...06 electra glide with 65,000 miles...=left
Trucky911
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
TheNorseman
Ignition/Tuner/ECM/Fuel Injection
1
10-02-2016 06:42 AM