Here is a pic of my cv carb set up. Have a questions re: the choke cable set up. I have seen what I think is the correct cable but I am not for sure. I dont understand how the cable gets connected to the carb. Can anyone shed some light on this? How did you mount the choke cable? I think my carb is a 1996.

Thanks
T-Ron

 

I don't know anything about that carb, but I don't see where choke lever is. Looks to me like it is probably on the other side of the carb. I see what looks like a link from the throttle connecting to the accel pump but that's all I can tell from looking at that pic. And I could be totally wrong.

 

Yep that's the wrong pic the hole where I think the choke goes is on the other side. My bad I will get the other side.

Thanks
T-Ron

 

I think the cable goes in the top hole its threaded

 

Check out this, lots of pics, may have what you need ...

Ironhead 40mm CV Carb Swap Today

 

Yes you are correct, you are just missing that plastic nut, spring and plunger. Plunger might be in that hole but I can't see it.
In plunger there is place for cable or lever, when you pull plunger out enricher is engaged.
If you are missing that plunger carb will not operate correctly.