Harley Davidson Forums - View Profile: Gman in NC


Gman in NC Gman in NC is offline

Road Warrior

About Me

  • About Gman in NC
    Gastonia, NC
    Cars, motorcycles, photography
    Technical Specialist, Nuclear Power (Retired)


Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 10-28-2017 06:26 PM
  • Join Date: 09-09-2009
  • Referrals: 1

Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. 08-03-2011 06:22 AM
    Hello gman,......we have a cpl things in common. I live not far from you in the mooresville lake norman area But the poor side of the interstate,lol) and I also ride a heritage and my wife of 30 years is from WV and she and I lived there back in the early 80s. I was a coal miner. We also live for the parkway. Go there as often as we can. Maybe you could join us sometime. I like to take old mountain road up through the wilksboro area or just run 64 to lenoir and then to blowing rock where we normally go toward ashville. Ride safe and often. Mark
  2. Gman in NC
    01-10-2011 06:44 PM
    Thanks. I kind of figured the overall width would make it. The rim width was a little concern but not that far off either. Thanks again. Gary
  3. 01-10-2011 11:31 AM
    charges = charts
  4. 01-10-2011 11:30 AM
    I have an 08 Heritage.

    If you can read the (tiny) print on those Dunlop charges I posted in that thread, you will notice that the overall width of the E3 160 is near the same as the 401 150, maybe even a hair narrower. Fit under the fender was not an issue at all.

    However, it is rated for a 3 1/2 rim and our rims are 3 inch.
    It's working out just fine on this bike, as well as my last bike. I like the tire.

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.