Installed 10” Factory 47 bars on my 2018 Road Glide Special
#1
Installed 10” Factory 47 bars on my 2018 Road Glide Special
I couldn’t find many photos of 10” Factory 47 bars so I decided to install and post some photos, maybe it could help someone trying to decide. I chose this size because I didn’t want the bars higher than the vent and windshield. Install was easy and I really am happy with the results.
The following 3 users liked this post by Fallenares:
#2
The following users liked this post:
Fallenares (05-22-2018)
#3
The following users liked this post:
Fallenares (05-22-2018)
#4
Join Date: Sep 2017
Location: 36.4279047 & -86.80480 or thereabout
Posts: 21,636
Received 32,997 Likes
on
12,901 Posts
The following users liked this post:
Fallenares (05-22-2018)
#5
#8
The following users liked this post:
rolling_again (06-26-2019)
#9
I’ve only put about 100 miles on it since I installed the bars, but I didn’t notice any added vibration. Did you also install new grips?
#10
Pulling the wires through was a little difficult at the points, but the Factory 47 video was helpful. On the video it shows that they de-pin the connector but on the 2018 the connector is tiny and can be left intact through the bars. Helps that the bars are 1.5” in diameter. Not sure how it would have been with thinner bars.