M8 Oil Transfer
I have a 2017 Ultra Low. Just had the 10K and service said there was an issue with too much oil in primary and lower levels in tranny? They said they called HD and was told to check levels frequently? Is there something more that can be done?
|
Check out the Fat Clutch Rod thread man......
|
If you want to stay under warranty do what Harley says. There's been a lot of M8's with this issue including mine.I fought with Harley for 2 years till they put a breather on the back side of the primary. The best thing you can do is find a harley rep. at a bike rally and tell him your problem and he will fix it. There is a lot of comments on this subject here on this forum. I'm not saying the fat clutch rod don't work but if you have anything problem your SOL.
|
Search “fluid transfer”
|
I thought there was a tech bulletin on this put out on this??
|
Originally Posted by jlombard
(Post 18174373)
If you want to stay under warranty do what Harley says. There's been a lot of M8's with this issue including mine.I fought with Harley for 2 years till they put a breather on the back side of the primary. The best thing you can do is find a harley rep. at a bike rally and tell him your problem and he will fix it. There is a lot of comments on this subject here on this forum. I'm not saying the fat clutch rod don't work but if you have anything problem your SOL.
Could you make a picture of the breather on the back side of the primary? I will send it to my dealer. |
https://cimg7.ibsrv.net/gimg/www.hdf...8327c17484.jpg
https://cimg8.ibsrv.net/gimg/www.hdf...73f8e8d570.jpg https://cimg9.ibsrv.net/gimg/www.hdf...bd4f8ca6ca.jpg https://cimg0.ibsrv.net/gimg/www.hdf...b76c21c884.jpg
Originally Posted by Alexspain
(Post 18195795)
Hello,
Could you make a picture of the breather on the back side of the primary? I will send it to my dealer. |
Is there any verification from those who’ve had that vent installed that it actually worked?
|
Originally Posted by SWThomas
Is there any verification from those who’ve had that vent installed that it actually worked?
|
Drilled a starter bolt all the way thru case and tig welded a small bleeder nipple to it......didn’t have a lot of transfer but none now....so I bet that vent will work.
|
All times are GMT -5. The time now is 06:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands