Hey guys, so I removed my primary and inner primary covers along with the compensating sprocket and main shaft clutch pack to replace seals, stator etc... after reinstalling everything I have absolutely no clutch! I've adjusted at the cable, at the clutch pack and absolutely nothing...

The only thing I can think of is I believe I shifted the bike while everything was disassembled, and I had that little rod that goes through the clutch to the transmission removed at the time. Is it possible something got misaligned or?


Im at my wits end, please help!!!!

P.S. Its a 2007 dyna with mid controls, any questions or suggestions would be really really appreciated!!

 

Check the snap ring holding the threaded adjuster into the clutch. Make sure it's seated ALL the way in.

 

The ***** on the clutch cable side ramp could have fallen out, this is assuming the clutch isn't disengaging.

 

Hit the nail on the head! Thanks a lot!

Oh and is it okay for the clutch adjustment plate in the primary to press against the snap ring?