Adjusted clutch and still will not disengage
#1
Adjusted clutch and still will not disengage
I have replaced my fritcion plates and 2 and third gear in my transmission. I replaced the clutch cable. I still can't get the clutch to disengage, when I turn the adjustment nut all the way tight the clutch will work but bike barly goes when you release the clutch. Engine revs up bike moves a little. I drove it trying to see if clutch plates were sticking but nothing. I keep trying to adjust it but it just will not work. Any suggestions besides adjust the cable I have read and adjusted for 1 week. I have broke it down 7 times and put the clutch back together. 1988 sportster 1200 4 speed
Last edited by Anthony Hamilton; 01-17-2017 at 09:56 AM. Reason: The actual push rods or the clutch adjusting screw . Would the push rods effect the clutch
#2
#3
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post
Slyvest
Primary/Transmission/Driveline/Clutch
1
06-06-2014 02:46 AM