Clutch Lever Replacement
#1
Clutch Lever Replacement
I changed my grips, control levers and mirrors on my '01 Road King over the weekend. The only thing I did was loosen the jam nut and loosened the long 1/2" cable nut in order c change the lever. I have never done this before so I want to make sure I have it adjusted properly. My question is do I need to remove the derby cover and adjust the clutch itself? Or do I just tighten the cable back so that when I pull back on the lever that it holds and releases when I put it in gear? Any advice so I don't have to take it to the dealer would be appreciated! Thanks in advance!
#2
In most cases just adjust cable correctly you should be ok if clutch was good before you changed it.
Adjusting the clutch on a 01 is really simple and something you should do your self . You can change engagement point to your liking . By how much you back it off between 1/2 and 3/4 turn. The cable is not a clutch adjustment it is a cable adjustment and free play.
1/2 turn clutch engages farther from the grip, 3/4 it engages closer to the grip anywhere in between fine tunes it.
Adjusting the clutch on a 01 is really simple and something you should do your self . You can change engagement point to your liking . By how much you back it off between 1/2 and 3/4 turn. The cable is not a clutch adjustment it is a cable adjustment and free play.
1/2 turn clutch engages farther from the grip, 3/4 it engages closer to the grip anywhere in between fine tunes it.
Thread
Thread Starter
Forum
Replies
Last Post
tbom4000
Primary/Transmission/Driveline/Clutch
6
04-20-2021 06:08 PM
ThePointman
Touring Models
24
04-13-2011 01:33 PM